Tribofilm Formation of Simulated Gear Contact Along the Line of Action

Reza Bayat, Arto Lehtovaara

Research output: Contribution to journalArticleScientificpeer-review

9 Downloads (Pure)


In this paper, an experimental simulation method was used for evaluating the tribofilm formation in rolling/sliding contact at different points in the line of action. A ball-on-disc test method was employed by which the pressure and slide to roll ratio of gear contact could be simulated. In order to reach a general conclusion, four different oils and two surface roughness were involved in the experiments. The tribofilm evolution was captured using spacer layer interferometry method, and the correlation of tribofilm with the location at the line of action was studied. Results showed that there is a threshold pressure for the tribofilm formation around which the tribofilm growth rate is maximum. Above this threshold pressure, the tribofilm formation is not stable, and the wear is dominant. Below this threshold pressure, the tribofilm growth rate rises by increasing the pressure and the gear contact is safely protected by a stable tribofilm.
Original languageEnglish
Article number126
Number of pages11
JournalTribology Letters
Issue number4
Publication statusPublished - 2021
Publication typeA1 Journal article-refereed

Publication forum classification

  • Publication forum level 1


Dive into the research topics of 'Tribofilm Formation of Simulated Gear Contact Along the Line of Action'. Together they form a unique fingerprint.

Cite this