Comparative study of laboratory-scale thermophilic and mesophilic activated sludge processes

Laboratory-scale mesophilic (20-35°C) and thermophilic (55°C) activated sludge processes (ASPs) treating diluted molasses wastewater were compared in effluent quality, removal of different COD fractions, sludge yield, floc size, and sludge settleability. The effect of polyaluminium chloride (PAC) with high cationic charge on sludge settleability and effluent quality was also studied. In the ASPs, the hydraulic retention time was 12 h in both processes, corresponding to a volumetric loading rate of 3.2±1.0 kg COD _filt m^-3 d^-1. The mesophilic ASP gave 79±18% and 90±2% and the thermophilic ASP gave 50±6% and 67±11% total COD (COD_tot) and GF/A-filtered COD (COD _filt) removals, respectively. The higher COD values in the thermophilic effluent were due to dispersed particles, such as free bacteria, measured as colloidal COD (COD_col=difference between soluble COD (COD_sol) and COD_filt). Both ASPs gave high (90%) COD _sol removals. Aeration (24-h) of the thermophilic ASP effluent at 35°C reduced the density of the free bacteria by half, which was also measured as 90% COD_col removal. Post-aeration of thermophilic effluent at 55°C had no influence either on the density of free bacteria or on the COD_col values. The use of PAC did not increase COD _tot or COD_filt removals in either process, but reduced the mesophilic and increased the thermophilic sludge volume index values.